10 Position crankshaft bearing caps in proper
order.
Note
The crankshaft bearing caps are marked with
code numbers at the marking points (arrows).
Tightening torque and rotation angle:
Crankshaft bearing bolts M 12
Crankshaft bearing bolts M 11
12 Measure crankshaft end play.
13 Turn crankshaft by hand and assure that it
runs free.
Installation of connecting rod bearings and
connecting rods
14 Insert connecting rod bearing shells, install
connecting rod bearing caps with bearing shells
and tighten connecting rod bolts to 30 Nm.
Connecting rod bearing shells are available only
in the yellow version.
03.10 - 320/15
90 Nm
55 Nm,
90 - 100" .
EXIT