Mercedes-Benz 603 Service Manual page 66

Special tool
603 589 00 15 00
01
Commercially available tool
Internal measuring instrument for 50 - 100 mm dia.,
with 0.01 mm increments and measuring point
pressure relief
Replacement
1 Press out cylinder sleeves.
2 Thoroughly clean basic bore.
3 Measure basic bore (D) in block.
If the limits are exceeded (see table) the block
cannot be reused.
4 Position new cylinder sleeves and press in
with press.
After pressing in cylinder sleeves maintain
pressure for approx. 7 seconds with press
(setting pressure).
01.10 - 115/3
e.g.
71
D-5000 Koln
Sunnen Grm -2125
EXIT