Mercedes-Benz 603 Service Manual page 50

35
Remove hex. head bolts (arrows) for drive
shaft on transmission flange and press drive
shaft off of transmission flange.
Installation note
Replace self-locking hex. nuts.
Tightening torque
Engine 602, 603.91
Engine 603.96
36 Loosen hex. head bolts (494) on drive shaft
intermediate flange.
Installation note
Tightening torque 25 Nm.
37 Loosen clamping nut (500) with open-end
wrench
126 589 00 01 00 (SW46) or
201 589 00 01 00 (SW41) and
torque wrench 001 589 66 21 00.
Push drive shaft back as far as possible (in
direction of arrow).
Installation note
Tightening torque 30 - 40 Nm.
Model 126:
38
Unbolt hex. head bolts (51) on cross
(50)
member center piece
member center piece.
Installation note
Replace self-locking hex. head bolts.
Tightening torque 45 Nm.
01.10 - 03006
40 Nm
60 Nm.
and remove cross
EXIT