Table of Contents
Advertisement
19 Fill plunger with engine oil. Press off ball
valve with a suitable pin and then ventilate the
working chamber by pumping the plunger, close
ball valve and possibly replenish oil. Then no oil
should escape from the ball valve when it is
gently compressed.
Note
If oil escapes, renew valve tappet.
20 Fill valve tappet with engine oil and insert
vented plunger with guide sleeve into the valve
tappet.
Fit guide sleeve Into valve tappet until the snap
ring engages, press in, if necessary.
21 Recheck dimension "Ll
22 Check oil supply to cylinder head.
this unscrew sealing plug of the oil channel
in cylinder head.
Blow compressed air into the oil channel, while
checking exit bores (arrows) at the seat for the
valve tappet for air.
23 Lubricate valve tappet and install in the same
position, noting sequence.
24 Install camshafts (05-220).
25 Install cylinder head cover, 10 Nm.
26
Install charge air pipe.
05.10 - 211 9
To
do
EXIT
Hide quick links:
Advertisement
Table of Contents
