Cylinder bores
Diameter "D" for cylinder sleeves
Standard 1)
There are no repatr stages for engmes with cylmder sleeves.
Dimensions for basic bore in block
Bore dia. " B"
Bore dia. ' ID"
Bore dia. " E"
Depth " A" sleeve seat
Depth " C" sleeve seat
Permissible out-of-round of basic bore in block
Permissible out-of-round and conicity of cylinder bore
Permissible roughness of cylinder bore (R3Z)
Permissible waviness of cylinder bore
l-loning angle
Roughness of block parting surface
Chamfer of cylinder bores
01 10
bore out to standard diameter " D" and hone,
see Note in (01-l 10). Observe group code
letters (A, X, B) (items 5 - 9).
602, 603
Cylinder dia. D in mm
over
over
92.650 - 92.750 mm
90.550 - 90.650 mm
90.000 - 90.935 mm
3.8 - 4.0 mm
4.77 - 5.23 mm
0.01 mm
0.07 mm
0.003 - 0.006 mm
50 % of roughness
45"
0.006 - 0.016 mm
30"
EXIT
87.000 - 87.006
87.006 - 87.012
87.012 - 87.018