Hardware Profile Forwarding-Mode Normal - Cisco Nexus 3548 Command Reference Manual

System Management Commands

hardware profile forwarding-mode normal

To enable normal mode, use the hardware profile forwarding-mode normal command. To disable
warp mode, use the no form of this command.
Syntax Description
lpm-entry
ipv4
multicast-entry
multicast
Command Default Disabled.
Command Modes Global configuration
Release
Command History
6.0(2)A8(1)
Usage Guidelines You must reload the Cisco Nexus 3548 switch after enabling the normal mode and also to revert to the
factory default from normal mode.
Examples This example shows how to enable normal mode:
switch(config)# hardware profile forwarding-mode normal
switch(config)#
This example shows how to disable normal mode:
switch(config)# no hardware profile forwarding-mode normal
OL-27851-02
hardware profile forwarding-mode normal
hardware profile forwarding-mode normal lpm-entry ipv4 multicast-entry multicast
no hardware profile forwarding-mode normal
no hardware profile forwarding-mode normal lpm-entry ipv4 multicast-entry multicast
Specifies lpm( non-host) entries.
The range of values for lpm-entry. Range: 4096-28672.
Specifies multicast entries.
The range of values for multicast-entry. Range: 4096-28672.
Modification
This command was introduced.
Cisco Nexus 3548 Switch NX-OS System Management Command Reference
hardware profile forwarding-mode normal
57