Adjusting The Dp Center Line - Kyocera TASKalfa 4500i Service Manual

Item No.
U072

Adjusting the DP center line

Description
Adjusts the scanning start position for the DP original.
Purpose
Make the adjustment if there is a regular error between the centers of the original and the copy
image when the DP is used.
Adjustment
1. Press the start key.
2. Press the system menu key.
3. Place an original on the DP and press the start key to make a test copy.
4. Press the system menu key.
5. Select the item to be adjusted.l
Display
Front
Back
CIS*
*: Dual scan DP only
6. Change the setting value using the +/- keys or numeric keys.
For copy example 1, increase the value. For copy example 2, decrease the value.
Increasing the value moves the image rightward and decreasing it moves the image leftward.
7. Press the start key. The value is set.
Caution
If the first side is adjusted, check the second side and if adjustment is required, carry out the
adjustment.
If the above adjustment does not optimize the center line, proceed with the following mainte-
nance modes.
U034
(P.1-3-34)
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Description
DP center line (first side)
DP center line (second side)
CIS center line
Original
Figure 1-3-16
U065
U067
(P.1-3-47)
(P.1-3-50)
1-3-56
Setting
range
-60 to 60
-60 to 60
-39 to 39
Copy Copy
example 1 example 2
U072
2LL/2LJ/2LH-1
Initial Change in
setting value per step
0 0.085 mm
0 0.085 mm
0 0.085 mm