Supplement 2; Setting Punch Destination - Kyocera TASKalfa 4500i Service Manual

Item No.
U224

Supplement 2

Displaying start display
The pre-installed graphics file is displayed at power on or recovering from sleeping.
Graphics display on service call display
The pre-installed graphics file is displayed at a service call.
How to change the message
Entering #562 (4 letters) using the numeric keypad during a service call display will let service
call messages 1 and 2.
How to reset the message display
Reverting the maintenance mode will automatically reset the message to the previous.
Caution
The graphics file for start display must be opaque. (To avoid the background from overlapping at
recovering from sleeping.)
The total size of the files installable is approximately 1.8 MB.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U234

Setting punch destination

Description
Sets the destination of punch unit of 1000-sheet finisher or 4000-sheet finisher.
Purpose
To be set when installing a different punch unit from the destination of the machine.
Setting
1. Press the start key.
2. Select the destination.
Auto
Japan Metric
Inch
Europe Metric
Initial setting: Inch (Inch specifications)/Europe Metric (Metric specifications)
3. Press the start key. The setting is set.
4. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Display
Conforms to destination settings.
Metric (Japan) specifications
Inch (North America) specifications
Metric (Europe) specifications
Description
Description
1-3-102
2LL/2LJ/2LH-1