Adjusting The Position Of The Center Adjuster (Center Line Alignment) - Kyocera AD-63 Service Manual

5FF

(4) Adjusting the position of the center adjuster (center line alignment)

Perform the following adjustment if the center lines of the copy image and the copy paper are misaligned.
Procedure
Enter maintenance mode.
Run maintenance item U993.
Select "VTC PG1" and output a
test pattern.
Is the center of the
image aligned with that of
the copy paper?
Loosen five screws 2 holding the
deck front cover and change the
position of the deck front cover so
that the level indicating the position
of the center adjuster and that of
the deck front cover are the same.
Retighten five screws 2.
Exit maintenance mode.
Level
indicators
1-4-4
Start
No
Yes
End
Screws 2
Level indicator
Center
adjuster
Screw 1 Screw 1
Figure 1-4-5 Adjusting the position of the center adjuster
Output example A
Retighten two screws 1 and
insert the drawer.
Loosen two screws 1 holding the
center adjuster and change the
position of the center adjuster.
• For output example A, move
the adjuster in the direction of
the black arrow (
• For output example B, move
the adjuster in the direction of
the white arrow (
Open the drawer.
Level indicator
Deck front cover
Screw 2
Output example B
Figure 1-4-4
).
).
Level
indicators