Table of Contents
Advertisement
7
Use [
][
and press [ENTER] on the first page.
8
Use [
][
used ("Not Specified", "256 kbps"–"18 Mbps"). (The
default maximum selectable value: "9.0 Mbps")
9
Press [START] to start the call.
10
When you want to end the call, press [END].
•
The Home screen is displayed.
Note
•
When using the KX-VC1300, you can have video conference calls with a maximum of 3 parties
simultaneously. When you are using the KX-VC1600, the maximum is 5 simultaneous parties, and if
you have the activation key (KX-VCS304) for enhanced features, you can make multiple-party video
conference calls with a maximum of 9 parties. When you are using the KX-VC2000, the maximum is
15 simultaneous parties, and if you have the activation key (KX-VCS305) for enhanced features, you
can make multiple-party video conference calls with a maximum of 19 or 23 parties.
•
The KX-VC1000 can connect with one party. Using the KX-VCS314 activation key allows you to
connect to up to 3 parties.
•
If an IPv4 address contains 1 or 2 digit numbers, enter these numbers as they are. Do not enter like
[.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
•
For the IPv6 address input format, refer to Page 47.
•
When making a call by specifying an IPv6 address port number, enclose the IPv6 address in square
brackets.
(Input example) [2001:db8::10]:5060
•
To initiate a video conference call by entering a SIP URI (SIP user name@SIP domain name), you
must set "SIP Server" to "ON" and specify "SIP Server Address", "SIP Username", and "SIP
Domain Name". Also, specify "Digest Authentication", "Authentication ID", and "Authentication
Password" as necessary (Page 144). For details, contact your network administrator.
•
When making a video conference call within your own SIP domain, you can make the call by entering
the other party's SIP user name. When the other party is not within your SIP domain, you must also
include their SIP domain name in addition to their SIP user name.
When a SIP domain name is not specified, your own SIP domain name is automatically appended to
the address and the call is made. Be careful as this may result in calling the wrong party.
•
See Page 47 for details about the characters that can be input for address entry.
Enter a standards-compliant value. For details, contact your network administrator.
•
To initiate a video conference call by entering an MCU's conference room number@IP address, "SIP
Server" and "Gatekeeper" must be set to "OFF" (Page 144, Page 145).
•
If the other party is using the KX-VC300/KX-VC600 with a software version older than 3.00 (not
including 3.00), you cannot make a video conference call using H.323. You must set "SIP" to "ON"
on the call type settings screen (Page 143).
•
Items that have been set to "OFF" on the call type settings screen (Page 143) cannot be set in the
connection mode settings.
•
You can refer to the contact list or call history when entering a destination by following the procedure
below from the manual dial screen (you cannot enter a destination using the profile):
When using IP mode: the IP address (or host name), SIP URI (or SIP user name), H.323 extension,
H.323 name, or MCU's conference room number@IP address
Document Version 2018-01
] to select "Outgoing Bandwidth / Site"
] to select the outgoing bandwidth/site to be
Starting a Video Conference
User Manual
57
Advertisement
Table of Contents
