Table of Contents
Advertisement
Preparation
•
If the value for "Primary DNS Server" or
"Secondary DNS Server" contains 1 or 2
digits numbers, enter these numbers as
they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
"LAN Mode (LAN 1)": Press [ENTER] and use
[
][
] to select the LAN mode.
–
"1 Gbps (Auto)": Negotiates with the other
party to determine the LAN mode. The
maximum setting is 1 Gbps (full duplex).
–
"1 Gbps (Fix)": Fixes the LAN mode to 1 Gbps
(full duplex).
–
"100 Mbps (Auto)" (default): Negotiates with
the other party to determine the LAN mode. The
maximum setting is 100 Mbps (full duplex).
–
"100 Mbps (Fix)": Fixes the LAN mode to 100
Mbps (full duplex).
–
"10 Mbps (Fix)": Fixes the LAN mode to 10
Mbps (full duplex).
Note
•
This setting is only displayed for the
KX-VC2000.
•
Match settings according to the hub or
router to be connected.
•
When "10 Mbps (Fix)" is set, set the "Max.
Bandwidth" of "Call set up" to 10 Mbps or
lower (Page 122).
16.
Press [G].
17.
Select "Yes" using [
•
Settings become effective after the automatic
restart.
Note
•
If the IP address or subnet mask contains an
invalid value, a message will appear requiring
you to enter a valid IP address or subnet mask.
•
A multicast address or broadcast address
cannot be used for the IP address.
•
If the unit is turned off and restarted before
completing step 14, you must start again from
step 1. If the unit is restarted after step 14 is
completed, you can restart from step 15.
50
User Manual
][
], then press [ENTER].
Document Version 2018-01
Advertisement
Table of Contents
