Meaning Of Leds - Siemens SINAMICS S110 Manual

8.4.5

Meaning of LEDs

Table 8- 18 Meaning of LEDs on the Sensor Module Cabinet SMC30
LED Color
RDY –
READY
Green
Orange
Red
Green/red Flashing
Green/red Flashing
Green/
orange
or
Red/
orange
OUT > –
5 V
Orange
Data on the parameters for activating the component recognition via LED, see SINAMICS S110 List Manual
1)
NOTICE
Damage to the encoder electronics due to incorrect voltage supply
If an encoder that is designed for a 5 V supply is operated with a 24 V supply, this can
destroy the encoder electronics.
• Make sure that the connected encoder can be operated with a 24 V power supply.
Cause and rectification of faults
The following documents contain information about the cause of faults and how they can be
rectified:
● SINAMICS S110, Function Manual
● SINAMICS S110, List Manual
SINAMICS S110
Manual, 07/2015, 6SL3097-4AC10-0BP5
Supplementary system components and encoder system integration
Status Description, cause
Off The electronics power supply is missing or outside the per-
missible tolerance range.
Continu- The component is ready for operation. Cyclic DRIVE-CLiQ
ous light communication is taking place.
Continu- DRIVE-CLiQ communication is being established.
ous light
Continu- This component has at least one fault.
ous light
Note:
LED is controlled independently of any reconfiguration of the
corresponding messages.
Firmware is being downloaded.
light 0.5
Hz
Firmware download is complete. The system waits for
light 2 Hz POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
Off The electronic power supply is missing or outside permissi-
ble tolerance range.
Power supply ≤ 5 V.
Continu- The electronics power supply for the encoder system is
ous light available.
Power supply > 5 V
8.4 Sensor Module Cabinet-Mounted SMC30
.
1)
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
–
–
199