Siemens SINAMICS S110 Manual page 137

Table 7- 6
Technical data
Setting the PROFIBUS address
1. Setting via the corresponding parameters (see SINAMICS S110 List Manual)
– The STARTER is used to set the bus address for a PROFIBUS node to a value
2. Manual setting
– The address switch (DIP switch) is used to manually set the bus address to a value
Setting the USS address
1. Setting via the corresponding parameters (see SINAMICS S110 List Manual)
– The STARTER is also used to set the bus address for USS nodes to a value between
2. Manual setting
– The address switch (DIP switch) is used to manually set the address to a value
SINAMICS S110
Manual, 07/2015, 6SL3097-4AC10-0BP5
PROFIBUS/USS address switch
between 1 and 126. This is only possible if the address switch is set to 0 or 127
(factory setting).
between 1 and 126. In this case, the parameter is only used to read the address.
0 and 30. This is only possible if the address switch is set to 0 or 127 (factory setting).
between 0 and 30. If addresses are set manually to values >30, the setting will revert
to the value set in the parameter or the default value.
Note
A value of 0 is used as the address for USS if no other address has been saved in the
parameter.
7.3 Interface description
Switch
S1
S2
S3
S4
S5
S6
S7
CU305 Control Units
Significance
2 = 1
0
2 = 2
1
2 = 4
2
2 = 8
3
2 = 16
4
2 = 32
5
2 = 64
6
137