Table of Contents
Advertisement
Ingeteam Inc
5. Installation
Before installing the Ingecon
the housing.
Check to ensure that there is no humidity inside the cabinet. If there are signs of humidity, the equipment should not
be installed until it has been completely dried out.
Before commencing the steps described in this point, it is important to identify each part described in this section
and to ensure that the right tools are on hand for the installation work.
All installation works have to comply with applicable Electric Security Laws.
5.1. General installation requirements
The equipment environment must be adequate and must comply with the guidelines set out in section "2. System
description". In addition, the items used in the rest of the installation must be compatible with the equipment and
comply with the applicable legislation.
Pay particular attention to the following:
•
The ventilation and work space must be adequate for maintenance tasks, in accordance with the applicable
regulations in force.
•
The external connection devices must be adequate and must be sufficiently close, as set out in the regula-
tions in force.
The lead-in cable cross-section must be adequate for the maximum current.
Particular care should be taken in order to ensure that there are no external items close to the air inlets and outlets,
which could prevent the correct ventilation of the equipment.
5.2. Wall mounting the equipment
The Ingecon
Sun Lite U units are equipped with a wall mounting system.
®
TL units
It provides a clamping plate attached to the equipment by a screw. This screw must be released in order to remove
the plate which should then be secured to the wall where the unit is to be mounted.
Once the plate has been removed, follow the steps detailed below:
1.
Mark the 5 holes on the wall using the template supplied with the unit.
2.
Drill holes in the wall with a recommended bit for the screw which will then be used to secure the plate to
the wall.
3.
Secure the plate with rawl plugs and stainless steel screws, to prevent corrosion, in the 1 and 2 marked
holes.
4.
We would recommend using appropriate lag screws for the wall construction material, washers and plugs for
fixing the plate to the wall.
5.
Hang the unit onto the plate.
28
Sun Lite U, the packaging should be removed, taking particular care not to damage
®
Installation manual
AAY2000IKI02
Hide quick links:
Advertisement
Table of Contents
