Personal Protective Equipment; Inspection, Operation And Manipulation Works; Inspection Works; Operation Works - Ingeteam Ingecon Sun 3.6TL U Installation Manual

Ingeteam Inc

4.4.2. Personal Protective Equipment

Inspection
Preventive maintenance tasks on the electric panels involve Inspection, Operation and Manipulation
tasks, depending on the case.
The use of safety footwear complying with the EN 345-1:1992 standard is mandatory. It is also mandatory to wear
security gloves or similar.
Operation
The use of a helmet compliant with EN 397:1995 is mandatory, and safety footwear complying with the EN 345-1:1992
standard. It is also mandatory to wear kid gloves or similar.
Manipulation
The use of a helmet compliant with EN 397:1995 is mandatory, and safety footwear complying with the EN 345-1:1992
standard.
It is also mandatory to use protective gloves made of insulating material for live working and compliant with the
EN-60903-1992 standard and the use of a face mask compliant with standard EN-168-1994, to provide protection
against electric shocks.

4.5. Inspection, Operation and Manipulation works

This section defines the mandatory preventive measures to be adopted when performing all types of work on the
equipment, in order to work safely and to control unavoidable hazards:

4.5.1. Inspection works

Opening system: a tool is necessary to remove the screws that close the frontal door.
It is strictly forbidden to access the enclosure from a part other than the one indicated in this manual.
Before opening any of the enclosure cover, it is first necessary to cut off the mains power supply to
the panel.

4.5.2. Operation works

The only operation work that can be done of this equipment is the upload of software to the RJ45 communication
connector.
Opening system: a tool is necessary to remove the screws that close the frontal door.
Operation works have the same preventive measures than Inspection works.
26
Installation manual
AAY2000IKI02