Table of Contents
Advertisement
Ingeteam Inc
WARNING
The opening of the various compartment enclosures in no way implies that no voltage is present
inside. Access is therefore restricted to qualified personnel following the safety conditions set out in
this document.
WARNING
The set of conditions detailed below should be considered to be the minimum requirements. It is
always preferable to disconnect from the mains and check that no voltage is present. Faults in the
installation could produce undesirable voltage returns. There is an electrical discharge hazard.
WARNING
In addition to the safety measures indicated in this manual, it is also necessary to observe the general
measures applicable to this field (specific to the installation, country, etc).
WARNING
Compulsory to verify that no voltage is present: Use CAT III - 600 V measuring equipment.
WARNING
Work always without voltage.
To consider an installation without voltage, at least the following five steps must be executed:
1.
Disconnect both DC and AC connections.
2.
Prevent any other feed.
3.
Verify that the installation is without voltage.
4.
Short-circuit AC connection and DC connection and connect it to Ground on the side without
voltage.
5.
Guard the installation from electric active elements physically close, and establish security
signals to limit the work zone and protect from any danger present in that zone.
Potential risks to persons
Here we detail the main hazards that an incorrect use of the inverter can cause on persons. Inside the manual they
are better explained.
WARNING: Electric Shock
The inverter can be charged even after being disconnected from Grid and PV Array for 5 minutes.
Be sure that the 5 steps needed to work without voltage have been completed.
WARNING: Explosion
There is a very low risk of explosion in case of a major malfunction.
Enclosure will protect persons and goods from explosions, but only if it is correctly closed.
WARNING: Crush
Follow always the instructions for moving the equipment and placing it. The heavy weight of this
equipment can cause severe damage or death if it is not manipulated correctly.
iv
Installation manual
AAY2000IKI02
Hide quick links:
Advertisement
Table of Contents
