Table of Contents
Advertisement
Ingeteam Inc
According to USA and Canada regulations, the electrical installation must not entail fire or explosion
hazards. Workers must be properly protected against the risk of accidents caused by direct or indirect
contact.
The electrical installation and the safety devices must take account of the voltage, all external condi-
tioning factors and the competence of those people having access to the installation parts.
According to USA and Canada regulations, on Electrical Hazards, for high voltage work, all workers
performing work in the open air shall stop work in the event of storms, heavy rainfall, strong winds,
snow or any other unfavorable environmental condition that hinders visibility or the handling of tools.
Work on indoor installations directly connected to overhead electricity lines must be interrupted in
the event of a storm.
According to USA and Canada regulations, all work equipment must be adequate for protecting
exposed workers against the risk of direct or indirect contact with electricity. At any event, the work
equipment electrical parts must comply with the provisions of the corresponding regulations.
Ingeteam Inc assumes no liability for damages caused by the improper use of the equipment.
Any work on any of this equipment involving a change in the original electrical layout, must first
be proposed to Ingeteam Inc. This proposed new layout must then be studied and authorised by
Ingeteam Inc.
The necessary safety measures must be in place to prevent unauthorized persons from handling the
equipment and to keep them away from the vicinity of the equipment.
Warning signs to indicate the presence of personnel at work. (Authorized
personnel only).
Lockout mechanisms or mechanical locking, by padlocks with keys, for
circuit breakers of an appropriate type.
These instructions must be easily accessible, close to the equipment and within easy reach of all users.
Before installing and starting up the equipment, please read these safety instructions and warnings carefully and all
the warning signs placed on the equipment. Ensure that all warning signs are perfectly legible and that any damaged
or missing signs are replaced.
4.3.1. Inspection work
It can involve opening the enclosure of the connection box for visual inspection. It will never involve opening the
enclosure of the equipment.
4.3.2. Operation work
Communication devices installation using RS485 communications terminal. It will never involve opening the enclo-
sure of the equipment or the connection box.
4.3.3. Manipulation work
It includes:
•
Replacement of short circuit protection fuses.
•
Replacement of grounding fuses (only in equipment with transformer).
Any work not classified as Inspection or Operation work may be consider Manipulation work.
24
Installation manual
AAY2000IKI02
Hide quick links:
Advertisement
Table of Contents
