Table of Contents
Advertisement
Installation manual
Moving the equipment with a fork-lift truck
At least the following points should be observed:
•
Ensure that the packed equipment is centred over the forks.
•
Try to ensure that the equipment is positioned as close as possible to the connection between the fork and
the carriage.
•
Ensure that the forks are perfectly level, in order to prevent the inverter package from being tipped off.
•
In any event, observe the instructions provided in the fork-lift truck manual.
Once the equipment has been moved to its place of installation, it should be left in the packaging until you are ready
to install it. Then, keeping it upright, you can move it a short distance without the packaging. The following points
should be observed, with regard to the inverter and the connection box.
Moving the equipment once the packaging has been removed
At least the following points should be observed:
•
Use the side grips to grasp the equipment with both hands.
•
Follow the ergonomic advice given for lifting heavy objects. The equipment weighs 52.91 lb (24 kg) and the
connection box of the 5U equipment.
•
Do not release the equipment until it is perfectly fixed in position or is firmly in place.
•
Ask another person to direct the movements to be made.
3.4. Storage
If the equipment is not to be installed immediately after reception, the following points should be taken into account
in order to avoid deterioration:
•
The package should be stored upright.
•
Keep the equipment free from dirt (dust, shavings, grease ...) and out of the reach of rodents.
•
Avoid contact with water jets, welding sparks etc.
•
Cover the equipment with a breathable, protective material in order to avoid condensation caused by ambient
humidity.
•
It is extremely important to protect the equipment from contact with chemicals, which could cause corro-
sion, and also from saline atmospheres.
3.5. Conservation
In order to conserve the equipment correctly, the original packing should not be removed until just before the equip-
ment is to be installed.
In the event of prolonged storage, we would recommend doing so in a dry place, avoiding abrupt temperature changes,
as far as possible.
When the packaging is damaged (cuts, holes etc) the equipment will not be maintained in optimum condition before
installation.
Ingeteam Inc assumes no liability if this condition is not complied with.
AAY2000IKI02
Ingeteam Inc
21
Hide quick links:
Advertisement
Table of Contents
