Safety Instructions; Contents; Symbols; Types Of Work To Be Performed - Ingeteam Ingecon Sun 3.6TL U Installation Manual

Installation manual

4. Safety instructions

4.1. Contents

This section contains the safety instructions to be followed when installing, operating and accessing the equipment.
Failure to comply with these safety instructions may result in physical injury or even death, or cause damage to the
equipment.
Before operating the equipment, please read these safety instructions carefully.

4.2. Symbols

Safety warnings, classified by colour according to their importance, provide information on conditions that could
cause serious bodily injury or death and/or damage to the equipment. Together with the warning sign, instructions are
given as to how to avoid such hazards.
These symbols are listed below, with an explanation of their meaning.
DANGER: High Voltage. Keep Away!
A warning that the high voltage present in the equipment could cause physical injury or even death
and/or damage to the equipment.
General warning regarding conditions that could result in physical injury and/or damage to the
equipment.
CAUTION: hot surface. Warning about the presence of hot parts that could cause serious burns.
All work-specific safety warnings and notes are included in each corresponding chapter and are also repeated and
completed at the critical points in that chapter.
Please read this information carefully. It has been written with your personal safety in mind, whilst ensuring the
maximum service life for the equipment itself and for any devices connected to it.

4.3. Types of work to be performed

Installation, commissioning, inspection and maintenance operations may only be performed by suitably
qualified personnel, trained to work with electrical equipment (hereinafter qualified personnel). You
are reminded that it is mandatory to comply with USA and Canada regulations.
The opening of the different compartment enclosures in no way implies that no voltage is present
inside. Access is therefore restricted to qualified personnel, observing the operating safety conditions
established in this document.
The set of conditions detailed below should be considered to be the minimum requirements. It is
always advisable to disconnect from the mains. The installation could be faulty, causing undesirable
voltage returns. There is an electrical discharge hazard.
In addition to the safety measures indicated in this manual, any general measures that may be appli-
cable should also be observed (installation-specific, country-specific, etc).
AAY2000IKI02
Ingeteam Inc
23