Table of Contents
Advertisement
Parameter
Test
5.1.4.5 Configuring P2P Settings
You can add the Device into your cell phone client or the platform to manage.
You can also configure P2P function by selecting Main Menu > NETWORK > P2P.
Make sure the DVR is connected into the Internet, and if yes, in the Status box of the P2P
interface, it shows Online.
After you have configured the network settings, on the NETWORK interface, click
Next.
The P2P interface is displayed. See Figure 5-16.
Enable the P2P function.
Description
which interrupt the network service. There is a pop-up message to
let you confirm if you want to save the modification, if yes, the
modification takes effect.
Suggested MTU values are as below.
1500: The biggest value of Ethernet information package. This
value is typically selected if there is no PPPoE or VPN
connection, and it is also the default value of some routers,
network adapters and switches.
1492: Optimized value for PPPoE.
1468: Optimized value for DHCP.
1450: Optimized value for VPN.
Click Test to test if the entered IP address and gateway are
interworking.
Local Configurations 40
Advertisement
Table of Contents
