Configuring Upnp Settings - Dahua Smart 1U User Manual

Interval (Sec.)
Health Enable
Interval (Min.)
Test
Click Apply to complete the settings.

5.14.1.7 Configuring UPnP Settings

You can map the relationship between the LAN and the WAN to access the Device on the LAN
through the IP address on the WAN.
Preparation for Configuration
Login the router to set the WAN port to enable the IP address to connect into the WAN.

Enable the UPnP function at the router.

Connect the Device with the LAN port on the router to connect into the LAN.

Select Main Menu > NETWORK > TCP/IP, configure the IP address into the router IP

address range, or enable the DHCP function to obtain an IP address automatically.
Configuration Steps
Select Main Menu > NETWORK > UPnP.
The UPnP interface is displayed. See Figure 5-173.
This is the interval that the system sends an email for the same
type of alarm event, which means, the system does not send an
email upon any alarm event.
This setting helps to avoid the large amount of emails caused by
frequent alarm events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Enable the health test function. The system can send a test email
to check the connection.
This is the interval that the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no
interval.
Click Test to test the email sending function. If the configuration is
correct, the receiver's email account will receive the email.
Before testing, click Apply to save the settings.
Local Configurations 195