Table of Contents
Advertisement
Configure the settings for the parameters of drawing rules. See Table 5-38Table
5-36.
Parameter
Description
Name
Enter the customized rule name.
Configure the actions that are defined as intrusion. You can select
Action
the Appear check box and the Cross check box.
In the Direction list, select the direction of crossing the configured
Direction
area. You can select Enter&Exit, Enters, and Exits.
Click
You can configure two filtering targets (maximum size and
Filtering Target
minimum size). When the target that is crossing the tripwire is
smaller than the minimum size or larger than the maximum size, no
alarms will be activated. The maximum size should be larger than
the minimum size.
Drag to draw an area.
Click Save to save the settings.
Click
to set the actions to be triggered. For details, see "5.10.2.1 Configuring
Tripwire Rules."
Select the Enable check box, and then click Apply.
to draw areas to filter the target.
Local Configurations 141
Advertisement
Table of Contents
