Alarm Input Settings - Dahua Smart 1U User Manual

Parameter
Max Temperature
Alarm Out
Latch
Send Email
Buzzer
Log
Voice Prompts
Click Apply to complete the settings.

5.10.5 Alarm Input Settings

Connect the alarm input and output ports by referring to "4.3 Connecting to Alarm Input and
Output." You can configure the alarm settings for each channel individually or apply the settings
to all channels and then save the settings.
5.10.5.1 Configuring Local Alarms
You can connect the alarm device to the alarm input port of the Device. When the alarm is
activated on the alarm device, the alarm information will be uploaded to the Device, and then
the Device outputs the local alarms in the way that you configure in this section.
Select Main Menu > ALARM > ALARM INPUT > Local.
The Local interface is displayed. See Figure 5-134.
Description
In the Max Temperature box, enter the max temperature value.
Click Setting to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm log.
Select to enable audio broadcast/voice prompts in response to a
Device alarm event.
Local Configurations 155