Dahua Smart 1U User Manual page 157

Parameter Description
Period Define a period during which the motion detection is active.
Click Setting to display setting interface.
Enable alarm activation function. Select the alarm output port(s) to
Alarm Out which the peripheral alarm devices are connected. When an alarm
event occurs, the system activates the peripheral alarm devices
connected to the selected output port.
Set a length of time for the Device to delay turning off alarm after
the external alarm is cancelled. The value ranges from 0 seconds
Latch
to 300 seconds, and the default value is 10 seconds. If you enter 0,
there will be no delay.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
Send Email
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL.
Select the channel(s) that you want to record. The selected
channel(s) starts recording after an alarm event occurs.
Record Channel
The recording for intelligence event and auto recording function
must be enabled. For details, see "5.1.4.9 Configuring Recorded
Video Storage Schedule" and "5.9.1 Enabling Record Control."
Click Setting to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the
preset that you want to be called when an alarm event occurs.
PTZ
Motion Detect can only activate PTZ preset.
Set a length of time for the Device to delay turning off recording
Post Record after the alarm is cancelled. The value ranges from 10 seconds to
300 seconds, and the default value is 10 seconds.
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are
Snapshot configured:


Buzzer Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm
Log
log.
Select to enable audio broadcast/voice prompts in response to a
Voice Prompts
human face detection event.
Click Apply to complete the settings.
The snapshot function is enabled for motion detect alarms in
Main Menu > STORAGE > SCHEDULE > Snapshot.
Select Main Menu > CAMERA > ENCODE > Snapshot, in
the Mode list, select Event.
Local Configurations 147