Dahua Smart 1U User Manual page 167

Parameter
Show Message
Alarm Upload
Send Email
Record Channel
PTZ
Post Record
Tour
Snapshot
Video Matrix
Buzzer
Log
Voice Prompts
Click Apply to complete the settings.
Description
Select the Show Message check box to enable a pop-up message in
your local host PC.
Select the Alarm Upload check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm
event occurs.
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for alarm and auto snapshot must be enabled. For
details, see "5.1.4.9 Configuring Recorded Video Storage Schedule"
and "5.9.1 Enabling Record Control."
Click Setting to display the PTZ interface.
Enable PTZ activation function. For each PTZ camera, select the
preset that you want to be called when an alarm event occurs.
Set a length of time for the Device to delay turning off recording after
the alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Select the Tour check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured in
Main Menu > DISPLAY > TOUR.
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are configured:
The snapshot function is enabled for motion detect alarms in Main

Menu > STORAGE > SCHEDULE > Snapshot.
Select Main Menu > CAMERA > ENCODE > Snapshot, in the

Mode list, select Event.
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in "Main
Menu > DISPLAY > TOUR."
Not all models support this function.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm log.
Select to enable audio broadcast/voice prompts in response to a local
alarm event.
Local Configurations 157