Table of Contents
Advertisement
Parameter
Snapshot
Video Matrix
Buzzer
Log
Voice Prompts
Click Apply to save the settings.
Click Default to restore the default setting.
Click Copy, in the Copy dialog box, select the additional channel(s) that you want
to copy the motion detection settings to, and then click Apply.
Click Test to test the settings.
Setting the Motion Detection Region
Next to Region, click Setting.
The region setting screen is displayed.
Point to the middle top of the interface.
The setting interface is displayed. See Figure 5-108.
Configure the regions settings. You can configure totally four regions.
Select one region, for example, click
Description
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, make sure the following settings are
configured:
The snapshot function is enabled for motion detect alarms in
Main Menu > STORAGE > SCHEDULE > Snapshot.
Select Main Menu > CAMERA > Snapshot, in the Mode list,
select Event.
Select the check box to enable the function. When an alarm event
occurs, the video output port outputs the settings configured in
Main Menu > DISPLAY > TOUR.
Not all models support this function.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm
log.
Select to enable audio broadcast/voice prompts in response to a
motion detection event.
.
Local Configurations 127
Advertisement
Table of Contents
