Sony MVS-6000 User Manual page 294
Multi format switcher system
with ccp-9000 series center control panel
Hide thumbs
Also See for MVS-6000:
- User manual (37 pages) ,
- Operation manual (18 pages) ,
- User manual (262 pages)
Table of Contents
Advertisement
Recording ancillary data
To record ancillary data in a frame memory clip, use the Frame Memory >Clip
>Record menu.
For details of the operating sequence, see "Clip Creation" (page 290).
To check ancillary data during recording
If the ancillary data to be recorded is embedded audio, by first setting the signal
output to through mode, you can listen while recording.
For the method of setting the signal output to through mode, see "Signal
Output Settings (Output Menu)" in Chapter 20 (Volume 3).
Note
For [Freeze Enable] or [Record Enable], in the <Record Enable> group,
pressing [Clip] or [Ext Clip] to turn them on or off may result in noise. Also,
with these buttons in the On state, selecting the signal on the frame memory
source bus may result in noise.
Playing back ancillary data
You can play ancillary data recorded in a frame memory clip by normal
playback or an auto transition of the clip transition.
To play the ancillary data, you must use the following procedure to enable
playback of the ancillary data. For the subsequent playback operation, see
"Clip Playback" (page 286).
Notes
• After recording a frame memory clip, the ancillary data state is enabled for
• To play back the clip, set the signal output to through mode. For the method
• When the reposition function is on, ancillary data cannot be played back.
• Switching reposition function between on and off may cause noise.
• Only the AUX bus and edit preview bus can output ancillary data.
• For loop playback of clips in the following video formats, the loop playback
• Recalling operations of still images or clips can cause noise.
• Carrying out file operations on a frame memory clip may result in the
• The audio sampling frequency is always 48 kHz.
294
Frame Memory Clip Operations
playback.
of setting through mode, see "Signal Output Settings (Output Menu)" in
Chapter 20 (Volume 3).
range must be at least 5 frames, and set to a multiple of 5 frames.
– 480/59.94i
– 720/59.94P
– 1080/59.94i
ancillary data being discontinuous, or in noise occurring. However, if the
first or last frame of the clip is deleted, noise will not occur.
Advertisement
Table of Contents
