Sony MVS-6000 User Manual page 359

Assignment of signals to output connectors
Note
The output connector OUT24 cannot be used.
Connectors to which the P/P row output signal assignment is fixed
The assignment of the following signals to output connectors OUT17 to OUT2
2 is fixed.
Except for Preset, you can select these signals on the AUX bus for output.
Output
connector
OUT17
OUT18
OUT19
OUT20
OUT21
OUT22
a) Depends on the setting in the Engineering Setup >Switcher >Config >M/E Output Assign menu.
Logical assignment of the physical PGM/PST
In the Engineering Setup >Switcher >Config >Logical M/E Assign menu, it is
not possible to assign the physical PGM/PST as a logical PGM/PST.
In the <Logical M/E to Physical P/P> group, you can select from M/E-1, M/E-
2, and M/E-3.
Configuration of the switcher bank outputs
If Multi Program mode is selected in setup (M/E Config in the Switcher
>Config menu), then for Bkgd in the PGM Config menu, it is only possible to
select Clean.
Assigning a simple P/P re-entry signal to a primary input
When returning output from a simple P/P to a primary input, use the following
procedure to set where the signal returns.
1
In the Switcher >Output menu, select [Output Assign] and press [Simple
P/P Re-Entry Assign].
The Simple P/P Re-Entry Assign menu appears.
Fixed assigned outputs
Standard mode
Program
Program
Preview
Clean
Key preview
Preset
Multi-program mode
a)
P/P OUT1
a)
P/P OUT1
a)
P/P OUT2
a)
P/P OUT3
a)
P/P OUT4
Preset
Simple P/P Software
359