Sony MVS-6000 User Manual page 190

2
3
4
5
For details of parameters, see step 3 of "Key control block (MKS-8035 Key
Control Module, option) operations for key shrinking, magnification and
movement" (page 188).
Entering parameters
This operation is the same as DME three-dimensional parameter input.
For details, see "Entering Three-Dimensional Parameter Values" in Chapter
11 (Volume 2).
Resetting parameters
This operation is the same as DME three-dimensional parameter resetting.
For details, see "Entering Three-Dimensional Parameter Values" in Chapter
11 (Volume 2).
Clearing resizer effects
To clear three-dimensional transform parameters only and set the
initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons.
To clear all resizer parameters, and set the initial state
In the device control block, press the [CLR WORK BUFR] button in the
operation buttons, twice in rapid succession.
For the initial state, you can select either the factory default settings or user
settings.
For details of how to make this selection, see "Selecting the State After
Powering On (Start Up Menu)" in Chapter 18 (Volume 3).
190
Resizer
Press the delegation button to select the key.
Press the [RSZR] button, turning it on.
• To change the aspect ratio, turn on the [LOC SIZE(ASP)].
• To shrink, magnify, or move the key, turn on the [LOC XYZ(LOC)].
Hold these buttons down while carrying out the operation of step 5 to
enable fine adjustment (fine mode).
Use the trackball for the operation.