Sony MVS-6000 User Manual page 108

7
Transition linked to the audio mixer
If the video signal selected in the background B row is linked to the audio mixer
in setup, then the audio mixer sound changes with the transition. That is,
pressing the [AUTO TRANS] button gives a cross fade, and pressing the
[CUT] button gives an instantaneous sound switch.
For details of setup, see "Cross-Point Settings (Xpt Assign Menu)" in Chapter
19 (Volume 3).
Notes
• The audio mixer is not linked to a snapshot or key frame transition.
• The audio mixer is not linked to a transition using the fader lever.
• If the bus-fixed mode (see page 128) is selected in the setup menu, and the
• The audio mixer is not linked to a key transition.
• In the following cases, the audio and video may be out of sync.
• For details of audio mixers that can be used, Sony service or sales
108
Procedure for Basic Transition Operation
DME Wipe: "Basic Procedure for DME Wipe Settings" (page 232)
Clip transition: "Clip Transition Operations" (page 296)
Using the transition preview function (page 131), you can check the
transition on the preview monitor.
Carry out the transition in the transition execution section.
For a gradual transition such as a mix (dissolve) or wipe: Press the
[AUTO TRANS] button, or operate the fader lever.
To execute a transition by pressing the [AUTO TRANS] button, first
set the transition rate (specified as the duration of the transition).
(See "Setting the Transition Rate" (page 120).)
When you have selected a wipe or DME wipe as the transition type,
you can also set the transition range. (See "Pattern Limit" (page 122).)
For an instantaneous transition: Press the [CUT] button.
For details, see "Executing a Transition" (page 119).
fader lever is in the lowest position, there is a cross fade from the audio
selected on the B row to the audio selected on the A row.
– When carrying out a cross fade in some DME wipes (for example, "picture
in picture")
– When executing a preset color mix in two-stroke mode
representative.