Sony MVS-6000 User Manual page 123

• When the limit value is set to 50%, the effect at the end of the transition is
the same as when the fader lever is at the center position in the normal case
(with the pattern limit function disabled); the wipe pattern does not complete.
• When the limit value is set to 0%, the wipe effect is completely disabled, and
carrying out the transition produces no change in the image.
• When the limit value is set to the maximum 100%, the image changes in
exactly the same way as when the pattern limit function is off, but when the
transition is completed, the cross-point selections on the background A and
B buses do not interchange.
There are two ways of setting a pattern limit: either by operating the fader lever
to save the fader position, or by using the Wipe menu or DME Wipe menu to
access the Edge/Direction menu for the M/E or PGM/PST bank.
Notes
• A pattern limit only applies when a wipe or DME wipe is selected as the
transition type.
• A pattern limit cannot be applied to an independent key transition (see page
133).
TRANS PVW button
PTN LIMIT button
LIMIT SET button
Setting the pattern limit with the fader lever
1
Move the fader lever to the position corresponding to a particular pattern
size.
• First make sure that the [PTN LIMIT] button is off.
• To check the pattern size on the preview monitor, first press the [TRANS
PVW] button, to select the transition preview mode (see page 131).
ON ON ON ON
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
BKBD KEY1 KEY2 KEY3 KEY4
KEY SUPER
MIX NAM
PRIOR MIX
PST
COLOR
ALL WIPE DME
MIX
PRIOR NORM TRANS
NORM REV
SET /REV PVW
AUTO
CUT
TRANS
Transition control block
PTN LIMIT
KF
LIMIT SET
Executing a Transition
123