Grandstream Networks GVC3200 Administration Manual page 55

http://arttel.ru
Horizontal Offset
Vertical Offset
Others
Fan Speed
Local RTP Port
Use Random Port
Disable in-call
DTMF display
Disable Remote
Control App
Connect
Remote Control
Touchpad
Sensitivity
Keep-alive Interval
(s)
STUN/TURN
Server
TURN Server
Username
TURN Server
Password
Firmware Version 1.0.1.48
http://arttel.ru/shop/videokonferentsii/grandstream-gvc3202
Fine-tunes the site name's position left or right on the local video.
Value range: 0%-96%. The default value is 0%.
Fine-tunes the site name's position up or down on the local video.
Value range: 0%-96%. The default value is 0%.
It is used to set the fan speed of the device, the default setting "Normal" means slow
speed and lower noise while "Full Speed" means fast speed and high noise.
This parameter defines the local RTP-RTCP port pair used to listen and transmit. It
is the base RTP port for channel 0. When configured, for audio, channel 0 will use
this port_value for RTP and the port_value+1 for its RTCP; channel 1 will use
port_value+6 for RTP and port_value+7 for its RTCP. For video, channel 0 will use
port_value+2 for RTP and port_value+3 for its RTCP; channel 1 will use
port_value+8 for RTP and port_value+9 for RTCP. The default value is 5004.
When set to "Yes", this parameter will force random generation of both the local SIP
and RTP ports. This is usually necessary when multiple devices are behind the
same full cone NAT. The default setting is "No".
Note:
This parameter must be set to "No" for Direct IP Calling to work.
It will enable/disable the device to omit the DTMF digits displaying from the LCD
screen. The default setting is "No".
If set to "Yes", the Remote Control app can be paired to the GVC3200/GVC3202 via
Bluetooth, but it cannot connect to the GVC3200/GVC3202 to perform any
operations. The default setting is "No".
Configure the sensitivity of the remote control trackpad. Users can select Slow,
Normal or Fast. The default setting is Normal.
It is used to specify how often the device will send a Binding Request packet to the
SIP server in order to keep the "ping hole" on the NAT router to open. The default
setting is 20 seconds. The valid range is from 10 to 160.
It is used to configure the URI of STUN (Simple Traversal of UDP for NAT) / TURN
(Traversal Using Relays around NAT) server. The device will send STUN Binding
Request packet to the STUN server to learn the public IP address of its network.
Only non-symmetric NAT routers work with STUN. The default setting is
"stun.ipvideotalk.com".
It is used to configure the username for TURN server.
It is used to configure the password for TURN server.
GVC3200/GVC3202 Administration Guide Page 54 of 71