Settings/Peripheral; Settings/Call Features - Grandstream Networks GVC3200 Administration Manual

http://arttel.ru

SETTINGS/PERIPHERAL

Peripheral section on Web page is the same on local LCD. Please refer to section PERIPHERAL in
chapter GVC3200/GVC3202 LCD

SETTINGS/CALL FEATURES

Parameters
Start Video
Automatically
Always Ring
Internal ringer
Disable DialPlan
Filter Characters
Disable Call-
Waiting
Disable Call-
Waiting Tone
Disable DND
Reminder Ring
Disable Direct IP
Call
Use Quick IP-call
mode
Firmware Version 1.0.1.48
http://arttel.ru/shop/videokonferentsii/grandstream-gvc3202
SETTINGS.
Descriptions
It is used to set if the device will enable the video feature automatically when it
makes an outbound call. If set to "Yes", the video codec attributes will be included in
the SIP INVITE message. Or the attributes will not be included. The default setting is
"Yes".
If set to "Yes", the device will always ring internal speaker. The default setting is
"No".
Defines whether to disable DialPlan in dial screen, contacts, incoming call and
outgoing calls and MPK. The default setting is "No".
Configures the characters for filter when dialing out numbers. Multiple characters are
allowed. For example, if set to [()-], when dialing (0571)-8800-8888, the characters
()- will be automatically filters and number 057188008888 will be dialed directly. The
default setting is [()-].
It is used disable call waiting feature. If it is checked, the devce will reject the second
incoming call during an active session without user's knowledge. But this missed call
record will be saved to remind users. The default setting is "No".
If set to "Yes", call waiting tone will be disabled when there is a new call during
active call. The default setting is "No".
It is used to set if the device will play the DND reminder ringtone for the incoming
call if the DND feature is enabled. If it set to "Yes", the device will keep mute instead
of playing a ring splash to indicate an incoming call when DND is enabled. The
default setting is "No".
It is used to set if the device allows the end users to make an outbound IP call. If it is
set to "Yes", the device will hide the IP call feature and end users will not be allowed
to make an outbound IP call. The default setting is "No".
It is used to set if the device will automatically fills in the first three octets to make an
outbound IP call regardless of subnet mask. If it is set to "Yes", users can dial an IP
address under the same LAN/VPN segment by entering the last octet in the IP
address from its local IP address. The port number used for the target IP address is
5060 by default. Please note the leading 0 in the last octet needs to be omitted.
For example, to make direct IP call to aaa.bbb.ccc.XXX, dial XXX on device directly.
No SIP server is required to make quick IP call. The default setting is "No".
GVC3200/GVC3202 Administration Guide Page 52 of 71