Grandstream Networks GVC3200 Administration Manual page 45

http://arttel.ru
Enable FECC
FECC H.224
Payload Type
H.264 Payload
Type
H.264 Image Size
H.264 Profile Type
Video Bit Rate
Firmware Version 1.0.1.48
http://arttel.ru/shop/videokonferentsii/grandstream-gvc3202
If set to "Yes", You can control the camera of the opposite side for video call, but the
opposite site must support FECC, and allow remote control on its local camera. The
default setting is "Yes".
It is used to configure FECC H.224 payload type. The valid range is from 96 to 127.
The default value is 125.
It is used to configure the H.264 codec message payload type format. The default
setting is 99. The valid range is from 96 to 127.
It is used to set the H.264 image size. It can be selected from the dropdown list.
 1080P
 720P
 4CIF
 4SIF
 VGA
The default setting is 1080P.
It is used to set the H.264 profile type. It can be selected from the dropdown list.
 Baseline Profile
 Main Profile
 High Profile
 BP&MP&HP
The default setting is "BP&MP&HP".
Lower profile is easier to decode while higher profile provides higher compression
ratio. For device with low CPU, select "Baseline Profile". Also, "Baseline Profile" is
likely to be used in a video conference that has high demanding for the video quality.
It is used to configure the bit rate of the video device. The default setting is
2048kpbs. It is recommended to increase bit rate if bandwidth allows. If the
bandwidth is not enough, the video quality will be reduced.

H.264 Image Size = 1080p, the Video Bit Rate can be set to an integer value
from 2048kbps to 4096kbps.

H.264 Image Size = 720p, the Video Bit Rate can be set to an integer value from
1024kbps to 2048kbps.

H.264 Image Size = 4SIF/4CIF/VGA, the Video Bit Rate can be set to an
integer value from 384 to 1024 Kbps.
GVC3200/GVC3202 Administration Guide Page 44 of 71