Grandstream Networks GVC3200 Administration Manual page 51

http://arttel.ru
Vendor Class ID
(Option 60)
DHCP Option 120
Override SIP
Server
IP Address
Subnet Mask
Default Router
DNS Server 1
DNS Server 2
PPPoE Account
PPPoE Password
802.1x Mode
802.1x Mode
802.1x Identity
802.1x Secret
Private Key
CA Certificate
Client Certificate
QoS
Enable LLDP
Firmware Version 1.0.1.48
http://arttel.ru/shop/videokonferentsii/grandstream-gvc3202
It is used to configure the vendor class ID header in the DHCP request. The default
setting is "Grandstream GVC3200" for GVC3200 and "Grandstream GVC3202" for
GVC3202.
Enables DHCP Option 120 from local server to override the SIP Server on the
device when DHCP is used. The default setting is "Yes".
It is used to configure the device's static IP address if the static IP is used.
It is used to configure the network's subnet mask if the static IP is used.
It is used to configure the network's gateway address if the static IP is used.
It is used to configure the primary DNS IP address if the static IP is used.
It is used to configure the secondary DNS IP address if the static IP is used.
It is used to configure the PPPoE account ID if the PPPoE is used.
It is used to configure the PPPoE password if the PPPoE is used.
It is used to enable and select the 802.1x mode for the device. The supported
802.1x modes are:

EAP-MD5

EAP-TLS

EAP-PEAP
The default setting is "Close".
It is used to fill in the identity information for the selected 802.1x mode. This setting
will be displayed only if 802.1x mode is enabled.
It is used to enter the secret for the 802.1x mode. This setting will be displayed only
if the 802.1x mode is enabled.
It is used to enter the private key password for the 802.1x mode. This setting will be
displayed only if the 802.1x mode is enabled.
It is used to upload the CA Certificate file to the device. This setting will be displayed
only if the 802.1x mode is enabled.
It is used to load the Client Certificate file to the device. This setting will be displayed
only if the 802.1x TLS mode is enabled.
It is used to enable the LLDP (Link Layer Discovery Protocol) feature on the device.
If it is set to "Yes", the device will broadcast LLDP PDU to advertise its identity and
capabilities and receive same from a physical adjacent layer 2 peer. The default
setting is "Yes".
GVC3200/GVC3202 Administration Guide Page 50 of 71