Safety - Danfoss VLT 5000 Series Operating Instructions Manual

These Operating Instructions can be used for all VLT 5000 Se-
ries frequency converters with software version 3.7x.
The software version number can be seen from parameter 624.
CE and C-tick labelling do not cover VLT 5001-5062,
525-600 V units.
These Operating Instructions are a tool intended for persons who are to install, operate and program the
VLT 5000 Series.
Operating Instructions:
Design Guide:
The Operating Instructions including Quick Setup are delivered with the unit.
When reading these Operating Instructions, you will come across different symbols that require special
attention.
The symbols used are the following:
Indicates a general warning
NB!:
Indicates something to be noted by the reader
MG.51.A9.02 - VLT is a registered Danfoss trademark
VLT 5000 Series
Operating Instructions
Software version: 3.7x
Gives instructions in optimum installation, commissioning and service.
Gives all required information for design purposes, and gives a good
insight into the technology, product range, technical data, etc.
®
VLT 5000 Series
Indicates a high-voltage warning
3