Optelecom-nkf Siqura C-54 E-MC User Manual page 71

Using the internal web pages
Receiver #
Source port filter
Connection priority
Reorder buffer size
Stream fail delay
FloodGuard enable
FloodGuard tx interval
Stream type
Link lost alarm timeout
Figure 7.53 Advanced settings, Receiver #
Can be used to filter incoming data traffic. With multiple signals
sent to the same IP address and destination port number,
Source port filter can be used to filter the input, i.e. to accept
only data from the transmitting port specified here. The filter
will not be active if set to 0 (the default and recommended
setting).
Parameter intended for use with the MX Software Development
Kit.
Used to reorder incoming packets.
[0...10000] ms. Default: 300 ms.
Should be on, to enable the sending of control messages. For
more information about FloodGuard, see section 7.7.2.
[1...1000] ms.
UDP, UDP + NKF. The UDP + NKF option will add an extended
RTP header for Optelecom-NKF applications requiring extra
information.
[1...1000] s. Time in seconds before alarm sent; default=10s.
- 67 -