Serial Absolute Synchronous Encoder Cable - Mitsubishi Electric R64MTCPU User Manual

Serial absolute synchronous encoder cable

Generally use the serial absolute synchronous encoder cables available as our products. If the required length is not found in
our products, fabricate the cable on the customer side.
Selection
The following table indicates the serial absolute synchronous encoder cables used with the serial absolute synchronous
encoder. Connector sets are also available for your fabrication.
Type
Q170ENCCBLM-A
Use the following or equivalent twisted pair cables as the serial absolute synchronous encoder cables.
Connector sets type
MR-J3CN2
Wire model
J14B103715-00 12pair(BLACK)
*1 "d" is as shown below.
d
Conductor Insulation sheath
*2 Standard OD (Outside Diameter). Maximum OD is about 10% larger.
CAUTION
• When fabricating the encoder cable, do not make incorrect connection. Wrong connection will cause runaway or explosion.
Length [m(ft.)]
2(6.56), 5(16.40), 10(32.81),
20(65.62), 30(98.43), 50(164.04)
Description
Servo amplifier connector
Core size Number Characteristics of one core
[mm2] of cores
Structure
[Number of
wires/mm]
0.2 24(12pair) 40/0.08
Wire model
J14B103715-00 12pair(BLACK)
Remark
Q171ENC-W8  MR-J4-B-RJ
Conductor Insulating
resistance sheath OD
*1
[/km] d[mm(inch)]
105 or less 0.88(0.035)
Remark
Q171ENC-W8  MR-J4-B-RJ
Finished OD Remark
*2
[mm(inch)]
Q171ENC-W8 
9.0(0.35)
MR-J4-B-RJ
APPENDICES
Appendix 1 Cables
A
77