Mitsubishi Electric R64MTCPU User Manual page 37

Item
Normal mode Digital oscilloscope
RUN
Ethernet information display mode
Installation mode
Built-in memory clear
Dot matrix LED
Displays "LOG" and "Mode"
alternately.(Left: When mode
is "RUN")
Displays "TRG" and "Mode"
alternately.(Left: When mode
is "RUN")
Refer to Ethernet information display mode for details of
the dot matrix LED display. (Page 37 Ethernet
information display mode)
"INS" is displayed
Displays "INS"  "SDC"
alternately.
"FIN" is displayed
"ER" is displayed
(Left: When there is a "SD
memory card access error")
"CLR" is displayed
Target memory is displayed.
Displays "CLR"  "Target
memory" alternately.
(Left: When target memory is
"standard ROM and backup
RAM")
"FIN" is displayed
"ERR" is displayed
Details
Displays the status of the digital oscilloscope wait for
trigger.
The mode displayed is the mode that the Motion CPU is
operating. ("STP", "RUN", "TES")
Displays the status after the digital oscilloscope trigger
issue.
The mode displayed is the mode that the Motion CPU is
operating. ("STP", "RUN", "TES")
Displays information of IP address, subnet mask, default
router address, MAC address, link status.
Mode to install the operating system software.
Displays the status of the operating system software
installation from the SD memory card.
Displays when the operating system software
installation from the SD memory card is completed
normally.
Displays when there was an error in operating system
software installation from the SD memory card.
 indicates the following errors.
0: SD memory card access error
1: Install file error
2: Built-in ROM access error
3: License key file error
Mode to clear the built-in memory (standard ROM,
backup RAM).
After displaying for 3 seconds, the display switches to
the target memory.
The target memory for built-in memory clear is
displayed.
The following are the displays for the target memory.
RB: Standard ROM and backup RAM
B: Backup RAM
R: Standard ROM
• Switch the memory displayed by pushing the SD
memory card access control switch.
Displays the status of the built-in memory clear.
Displays when built-in memory clear is completed
normally.
Displays when an error occurred during built-in memory
clear.
2 EQUIPMENT SPECIFICATIONS
2.2 Motion CPU Module
2
35