Rs232 Faceplate Port - GE G30 Instruction Manual
Ur series generator protection system
Hide thumbs
Also See for G30:
- Instruction manual (696 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (614 pages)
Table of Contents
Advertisement
3 HARDWARE
3.2 WIRING
3
Figure 3–26: RTD CONNECTION
3.2.8 RS232 FACEPLATE PORT
A 9-pin RS232C serial port is located on the G30 faceplate for programming with a computer. All that is required to use this
interface is a computer running the EnerVista UR Setup software provided with the relay. Cabling for the RS232 port is
shown in the following figure for both 9-pin and 25-pin connectors.
The baud rate for this port is fixed at 19200 bps.
NOTE
Figure 3–27: RS232 FACEPLATE PORT CONNECTION
GE Multilin
G30 Generator Protection System
3-29
Advertisement
Table of Contents
