GE G30 Instruction Manual page 119

4 HUMAN INTERFACES
Viewing the settings in template mode also modifies the settings tree, showing only the settings categories that contain
editable settings. The effect of applying the template to a typical settings tree view is shown below.
Typical settings tree view without template applied.
Figure 4–5: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE SETTINGS COMMAND
Use the following procedure to display settings available for editing and settings locked by the template.
1. Right-click the device in the Online or Offline Window area and apply the template by selecting the Template Mode >
View All Settings option.
2. Enter the template password then click OK to apply the template.
Once the template has been applied, users are limited to edit the settings specified by the template, but all settings are
shown. The effect of applying the template to the phase time overcurrent settings is shown below.
Phase time overcurrent settings window without template applied.
Figure 4–6: APPLYING TEMPLATES VIA THE VIEW ALL SETTINGS COMMAND
e) REMOVING THE SETTINGS TEMPLATE
Once a settings template is removed, it cannot be reapplied and a new settings template needs to be defined before use.
3. Right-click the device in the Online or Offline Window area and select the Template Mode > Remove Template
option.
4. Enter the template password and click OK to continue.
GE Multilin
4.2 EXTENDED ENERVISTA UR SETUP FEATURES
Typical settings tree view with template applied via
the Template Mode > View In Template Mode
command.
Phase time overcurrent window with template applied via
the Template Mode > View All Settings
The template specifies that only the
settings be available.
G30 Generator Protection System
842860A1.CDR
command.
Pickup and Curve
842859A1.CDR
4-7
4