Installation - GE G30 Instruction Manual
Ur series generator protection system
Hide thumbs
Also See for G30:
- Instruction manual (696 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (652 pages)
Table of Contents
Advertisement
5.2 PRODUCT SETUP
PATH: SETTINGS
PRODUCT SETUP
INSTALLATION
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until
RELAY SETTINGS
UNIT NOT PROGRAMMED
The
setting allows the user to uniquely identify a relay. This name will appear on generated reports.
RELAY NAME
5
5-98
INSTALLATION
RELAY SETTINGS:
Not Programmed
RELAY NAME:
MESSAGE
Relay-1
is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
self-test error message is displayed until the relay is put into the "Programmed" state.
G30 Generator Protection System
5.2.18 INSTALLATION
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5 SETTINGS
GE Multilin
Advertisement
Table of Contents
