Zeroing/Taring The Scale; Mixing Without Job - Sartorius PMA.Vision Operating Instruction

Operation
0
Max. 7500 g d=0.1 g
249.2
G
+
Factor
1.00
0
Max. 7500 g d=0.1 g
0.0
G
Main job information
2nd job information
Mixing w/o job
0
Max. 7500 g d=0.1 g
249.2
G
+
Factor
1.00
0
Max. 7500 g d=0.1 g
249.2
G
+
Factor
1.00
VIS1X
28 Operating Instructions
6.3

Zeroing/Taring the Scale

Remove the load from the scale.
t
1
Select [0] (1) to zero the scale.
t
All weight values are measured based on this zero point (zeroing
within ±2% of the weighing range around the zero point).
g
The scale is zeroed and the calculation factor is reset.
y
START
Place an empty container on the scale, if weighing with containers.
t
Select [0] (1) to tare the scale.
t
The scale displays zero again after being tared. The tared value is subtracted from
the overall weighing range of the scale. The scale can be tared throughout its entire
weighing range.
The scale is tared and the calculation factor is reset.
y
g
Factor
START
1.00
6.4

Mixing without Job

Select the [Mixing w/o job] button in the Sartorius menu (1).
t
The [Weighing] application appears.
y
1
Remove the load from the scale.
t
1
Select [0] (1) to zero the scale.
t
g
START
Place the sample on the weighing pan.
t
You can read the measured value as soon as the weight value (1) stops changing and
the unit is displayed.
The scale stability is displayed as soon as the weighing result is constant within a
1
defined range. Until stability is reached, the measured value is shown in gray on the
g
display and only turns black once the scale is deemed stable.
START