Installation; Scope Of Delivery; Unpacking The Device; Selecting A Setup Location - Sartorius PMA.Vision Operating Instruction

Installation

VIS1X
20 Operating Instructions
5 Installation
5.1

Scope of Delivery

Item
Large weighing pan: d 233 mm
USB cable, 3 m
Power supply YPS07-USB
Ex-link converter
Link cable from converter to scale
Installation Instructions
5.2

Unpacking the Device

Procedure
Open the packaging, making sure to remove all parts carefully.
t
After unpacking the device, check it immediately for any external damage.
t
If you detect any damage, proceed as directed in Chapter "12.2 Shipping-related
t
Tasks/Returns", page 50.
If the device is stored temporarily: Observe the information on storage (see
t
Chapter "12.1 Storage", page 50).
Save the box and all parts of the packaging for any future transport. All cables
t
should be unplugged when transporting.
5.3

Selecting a Setup Location

Select the right setup location:
− Set up the device on a stable, even surface that is not exposed to vibrations.
− Maintain free access to the device at all times.
− The devices must be handled carefully according to the IP protection rating.
The environment must be suitably secured.
− In the event of use in systems and under ambient conditions with higher safety
requirements, you must observe the requirements and provisions applicable in
your country.
Choose a location that is not subject to the following negative influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, AC systems, and doors
− Extreme vibrations during weighing
− Heavy traffic areas (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a cold device when
it is brought into a warm area. You should therefore let a device that has been
disconnected from its power source acclimatize for approximately 2 hours before
reconnecting it to the supply voltage.
Quantity
1
1
1
1
1
1