Introduction
1.1
Purpose of this document
This programming manual contains all information that you will require to commission and
use the device.
It is aimed at persons who install the device mechanically, connect it electrically,
parameterize and commission it, as well as at service and maintenance engineers.
This document also contains special information and safety notes that you will require when
using an SIL-certified device in safety-instrumented systems.
1.2
History
This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation of this edition is applicable for the following firmware:
Edition
07
09/2007
The most important changes in the documentation when compared with the respective
previous edition are given in the following table.
Edition
07
09/2007
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
Firmware identification
FW: from 5.00.00 onwards
Remark
Additional parameters and diagnostics enhancement
•
Newly added contents for operating with natural gas and for functional safety
•
Entirely revised edition
•
System integration
SIMATIC PDM V6.0
1
11