Iy Module - Siemens SIPART PS2 PA 6DR55 Series Operating Instructions Manual

5.2

Iy module

Function
● The optional I
● The current actuator position is indicated only after a successful initialization.
Figure 5-3
Device features
The I
● Single channel
● Potentially separated from the standard controller.
Installing the I module
y
Proceed as follows to install the optional I
1. Slide the I
2. Connect the module to the motherboard. For this purpose, use the 6-pole flat ribbon
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
module indicates the current actuator position as a dual line signal with
y
I = 4 to 20 mA. The I
y y
Thanks to the dynamic control, this module can report the arising operational faults
automatically.
I module
y
module is:
y
module up to the end stop in the lower stack of the module rack.
y
cable provided.
module is potentially separated from the standard controller.
module:
y
Installing the optional modules
5.2 Iy module
61