Table of Contents
Advertisement
Figure 5-7
Installation
Proceed as follows to install the EMC filter module:
1. Remove the module cover.
2. Dismantle all existing optional modules.
3. Unlatch the fixing screws of the module rack that is opposite to the blanking plugs.
4. The EMC filter module has a fastening hole. Fasten the module on the module rack using
5. Lay the ribbon cable of the EMC filter module towards left through the opening of the
6. Unplug the connector of the internal potentiometer from the motherboard.
7. Connect the ribbon cable of the EMC module to the motherboard.
8. Connect the external position sensor to the terminals of the EMC module.
9. Reinstall the other optional modules in the reverse order.
10. Install the module cover.
See also
Installing the module cover (Page 60)
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
EMC module
the fixing screws.
module rack.
Installing the optional modules
5.6 EMC filter module
69
Advertisement
Table of Contents
