Siemens SIPART PS2 PA 6DR55 Series Operating Instructions Manual page 132

Commissioning
9.4 Commissioning the part-turn actuators
7. Determine the end position 1 of the actuator.
8. Move the actuator spindle to the desired position by pressing the increment or
decrement buttons.
9. Accept the current position by pressing the
shown on the digital display:
Note
RANGE fault message
• The selected end position is beyond the permissible measuring range if the "RANGE"
• Move the actuator spindle to another position using the
• Abort the manual initialization process by pressing the
10. Determine the end position 2 of the actuator.
11. Move the actuator spindle to the desired position by pressing the
decrement buttons.
12. Accept the current position by pressing the
13. The initialization process is automatically resumed. Displays for the initialization steps
from "RUN1" to "RUN5" are shown in the lower line on the digital display.
14. The following display indicates that the initialization has been completed successfully:
Aborting the manual initialization process
1. Press the
The positioner is in the "Configuration" mode.
2. Exit the "Configuration" mode. Keep the
than 5 s.
3. The software status is displayed.
4. After releasing the
i.e. the positioner has not been initialized.
132
message appears on the digital display. Correct the settings as follows: Move the
friction clutch until the digital display shows "OK". Press the operating mode button
again.
buttons.
Switch to the "P manual mode" and adjust the actuator travel and the position
displacement sensor.
operating mode button. The digital display shows the "INITM" parameter.
operating mode button, the positioner is in the "P manual mode",
operating mode button. The following is
increment or
operating mode button.
operating mode button.
operating modes button pressed for more
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
decrement
increment or