Automatic Initialization Of Part-Turn Actuators - Siemens SIPART PS2 PA 6DR55 Series Operating Instructions Manual

Electropneumatic positioner
Table of Contents

Advertisement

3. After checking, move the actuator to a central position. This accelerates the initialization
9.4.2

Automatic initialization of part-turn actuators

Condition
The following conditions must be fulfilled before activating the automatic initialization:
1. The actuating range of the actuator can be passed through completely.
2. The actuator shaft is at a central position.
Initializing the positioner automatically
1. Switch to the "Configuration" mode. Keep the operating modes buttons pressed for more
2. Change the actuator type from linear to the part-turn actuator. Change the parameter
3. Call the second parameter "YAGL". Press the
4. Call the fourth parameter "INITA". Press the
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
Note
Press the
increment or
faster.
process.
than 5 s for this purpose. The following is shown on the digital display:
setting using the
decrement button. The following is shown on the digital display:
for this purpose. This parameter has already been set to 90° automatically. The following
is thus shown on the digital display:
for this purpose. The following is shown on the digital display:
9.4 Commissioning the part-turn actuators
decrement buttons additionally to reach the end position
operating mode button for a short while
operating mode button for a short while
Commissioning
129

Advertisement

Table of Contents
loading

Table of Contents