Overview Of Parameters 6 To 53 - Siemens SIPART PS2 PA 6DR55 Series Operating Instructions Manual

Parameter assignment/Addressing
10.1 Overview of the parameters
Parameter Function
3.YWAY
2)
Range of stroke (optional setting)
4.INITA Initialization (automatic)
5.INITM Initialization (manual)
Set the transmission ratio selector accordingly.
1)
The parameter only appears for "WAY" and for "ncSLL".
2)
When used the value must correspond with the set range of stroke on the actuator.
3)
Carriers must be scaled to the actuator's stroke value,or if this is not scaled they then must be set to the next
largest scaled value.
10.1.2

Overview of parameters 6 to 53

Note
The following table contains the parameters required to operate the positioner. Factory-set
parameter values are printed in bold.
Overview of parameters 6 to 53
Parameter Function
6.SDIR Setpoint direction
7.TSUP Setpoint ramp OPEN
8.TSDO Setpoint ramp CLOSED
9.SFCT Setpoint function
136
Overview of the positioner parameters 6 to 53
Ascending
Decreasing
Linear
Equal percentage
Inverse equal percentage
Parameter values
3)
40 | 50 | 60 | 70 | 90 | 110 | 130
Parameter values
1 : 25
1 : 33
1 : 50
25 : 1
OFF
5 | 10 | 15 | 20
(Short lever 33°)
25 | 30 | 35
(Short lever 90°)
(Long lever 90°)
NOINI | no / ###.# | Strt
NOINI | no / ###.# | Strt
riSE
FALL
Auto / 0 ... 400
0 ... 400
Lin
1 - 25
1 - 33
1 - 50
n1 - 25
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
Unit
mm
Unit
s
s